This was an ornament I printed roughly 6 years ago. Being a Christmas ornament it spent most of those 6 years stored in my roof space.

Being in Australia this would have been subject to average temperatures of 30 to 35 degrees c but also peaks across summer approaching 70 degrees c. Also in high humidity.

The PLA crumbles into tiny pieces at the softest touch.

I thought it was interesting that PLA would start to break down in these conditions.

  • CaptainBlagbird@lemmy.worldEnglish
    21·
    4 days ago

    average temperatures of 30 to 35 degrees c but also peaks across summer approaching 70 degrees c. Also in high humidity.

    Oh Australia… 🫠

    • BearOfaTime@lemm.eeEnglish
      11·
      4 days ago

      You’d get those kinds of attic temps in many places in the US.

      Attics are no place to store stuff, keeping them under 140f in the summer is a challenge