atocci@kbin.social to 3DPrinting@lemmy.world · edit-21 year agoUh, is this a loose thermistor?media.kbin.socialimagemessage-square22fedilinkarrow-up120arrow-down10
arrow-up120arrow-down1imageUh, is this a loose thermistor?media.kbin.socialatocci@kbin.social to 3DPrinting@lemmy.world · edit-21 year agomessage-square22fedilink
minus-squaren3m37h@lemmy.worldlinkfedilinkEnglisharrow-up5·1 year agoHave you tried leveling your bed? On a serious note, do you have thermal grease on the thermistor?
minus-squareatocci@kbin.socialOPlinkfedilinkarrow-up3·1 year agoI assume so? The original hot end came with it pre-applied, so I think the spare the printer came with should too, but I haven’t checked this one.
minus-squaren3m37h@lemmy.worldlinkfedilinkEnglisharrow-up3·1 year agoDont assume, it makes an ASS out of U and ME. Check it
Have you tried leveling your bed?
On a serious note, do you have thermal grease on the thermistor?
I assume so? The original hot end came with it pre-applied, so I think the spare the printer came with should too, but I haven’t checked this one.
Dont assume, it makes an ASS out of U and ME. Check it