Advantage of 3D printing is that you can virtually print anything you want and have it available to use within minutes to a few hours without leaving your place or order something to be delivered. The down sides are that it usually needs to be designed with 3D printing in mind. It’s also a bit weaker due to the layer adhesion, it’s surface finish is not as precise (resin is another story though) Also with a decentralized manufacture there is no QC possible so if you design something and put it up online the quality will vary depending on who prints it and on what. Finally, there’s a problem with IP, when you manufacture a mold and inject then sell, you can charge per item, with 3 D print you may pay for the STL but the. There are no restrictions on how many copies you can make. So it’s a challenge to adapt pricing of designs if you’re looking to make a profit from it.
Advantage of 3D printing is that you can virtually print anything you want and have it available to use within minutes to a few hours without leaving your place or order something to be delivered. The down sides are that it usually needs to be designed with 3D printing in mind. It’s also a bit weaker due to the layer adhesion, it’s surface finish is not as precise (resin is another story though) Also with a decentralized manufacture there is no QC possible so if you design something and put it up online the quality will vary depending on who prints it and on what. Finally, there’s a problem with IP, when you manufacture a mold and inject then sell, you can charge per item, with 3 D print you may pay for the STL but the. There are no restrictions on how many copies you can make. So it’s a challenge to adapt pricing of designs if you’re looking to make a profit from it.