I have a Nevermore filter with 24v fans, would it be fine to connect them to the parts that I have circled on my Prusa MK4?

Or is that dangerous?

    • FuglyDuck@lemmy.world
      link
      fedilink
      English
      arrow-up
      2
      ·
      1 year ago

      If the charger is a 24v powesupply, that would work. I would also suggest getting a switch to put in line so you don’t have to keep unplugging it- either a rocker switch or mini toggle.

      • chrischryse@lemmy.worldOP
        link
        fedilink
        English
        arrow-up
        1
        ·
        1 year ago

        Not sure how familiar you are with electronic stuff, but the fans I have are 24v and 0.1A my laptop charger outputs up to 6A that shouldn’t be an issue right?

        • FuglyDuck@lemmy.world
          link
          fedilink
          English
          arrow-up
          1
          ·
          1 year ago

          Volts need to match, nominally.

          Your fans will only draw .1A from the supply- as long as your supply has enough amperage to supply everything running… your fine.

            • FuglyDuck@lemmy.world
              link
              fedilink
              English
              arrow-up
              1
              ·
              1 year ago

              19 is probably fine. Voltage is always a bit inconsistent so the phrase they use is “nominal”- or “more or less”

            • CmdrShepard@lemmy.one
              link
              fedilink
              English
              arrow-up
              1
              ·
              1 year ago

              With a fan it won’t be a big deal if the charger outputs 19-24V. Do you have a multimeter? Do you have a 24V source anywhere on the board? Using a laptop charger for 24V/0.1A is just way overkill. It’ll work just fine though. You might also get some 24V LEDs to run off it too since you’ll have all that extra current capacity.