Any ideas as to what I’m doing wrong?

This sphere has a ridge on it, and I’ve had miniatures come out with the base to be slightly offset giving a bit of a ridge.

I’m using a Halot One, lychee Slicer, and Anycubic Water Wash resin.

  • JoShmoe@programming.dev
    link
    fedilink
    English
    arrow-up
    3
    arrow-down
    1
    ·
    11 months ago

    That ridge looks like it’s part of the model. Can you confirm its not supposed to be there?

    • Tarnaq@lemmy.worldOP
      link
      fedilink
      English
      arrow-up
      2
      ·
      11 months ago

      It’s not supposed to be there, there was no ridge when I was supporting and slicing.

      • GrindingGears@lemmy.ca
        link
        fedilink
        English
        arrow-up
        2
        ·
        11 months ago

        If it’s in the same spot every time, it’s very likely something wrong with the model. It’s inexplicable when this happens, but it does sometimes. Could try a different sd card, doubt that will make a difference, but you never know.

        To me, it looks too uniform and consistent to be something with the printer.