Since, my doctor recommend that I put more fiber in my diet- I decided to comply.
So… in a few hours, I will be running a few OS2 runs across my house, with 10G LR SFP+ modules.
Both runs will be from my rack to the office. One run will be dedicated for the incoming WAN connection (Coupled with the existing fiber that… I don’t want to re terminate). The other, will be replacing the 10G copper run already in place, to save 10 or 20w of energy.
This, was sparked due to a 10GBase-T module overheating, and becoming very intermittent earlier this week causing a bunch of issues. After replacing the module, links came back up and started working normally… but… yea, I need to replace the 10G copper links.
With only twinax and fiber 10G links plugged into my 8-port aggregation switch, it is only pulling around 5 watts, which is outstanding, given a single 10GBase-T module uses more then that.
Edit,
Also, I ordered the wrong modules. BUT… the hard part of running the fiber is done!
Was thinking of going the same route, as my employer threw away a couple of good working 10G optic sfps, but alas, only 1 of my 2 netgear switches supports sfp+ modules. (Couldn’t even get a simple 1.25G utp sfp to work in it)
I have a 100$ or so mikrotik here in the office, which is on the other end of that fiber. Its not at all picky on module choice.
Also- neither my brocade nor unifi aggregation switch are picky on modules. They have so far, taken every module I have tried.
The Intel X520-based daughterboard for my r730 though, its extremely picky. Gotta be intel/dell.