Almost every one of the fingerprint sensors in laptops are not supported by Linux due to proprietary protocols. Never managed to get stuff used by Dell or HP with Linux.
But the Grow R503 can be used over uart, what can be connected to usb with some minor additional parts.
Yes, it would be unfortunate for a new user to experience all the horror our distinguished friend EvilSocket is telling everyone today…
Keep up the good work!
Did you uninstall cups and avahi?
Ender. Happened back in the days with a 3v2, the stepper drivers on the original mainboard overheat, causing it to ‘miss’ steps.
Replaced the MB with an improved version, tuned the vRef and never had any issues again.
You might look into tuning the vRef for your machine.
That’s my understanding.
And I think a small fee to get out of the googlyclaws. Paying $100 once, to host immich for the family and supporting development is a no brainer to me.
But I understand not everyone has the resources or is willing to donate.
This is just the beginning…
Cars.
You get it…
Thanks for this. Finamp looks really nice.
That is not how it is supposed to look, the end result should be at least a couple of inches wide.
Maybe you don’t need to ‘fix’ your retraction settings?
If it looks good enough, why bother?
Wasn’t aware of the test (SuperSlicer user here), and found this.
The tower has multiple notches, each one corresponding to a different retraction length. By looking at the tower after printing, you can see how each retraction length affects the print quality.
So check your surface finish and select the retraction value with the best looks.
Esp32Cam with esphome running a webserver, add frigate in the mix and you can have dozens of cameras for just a few bucks.
Completely open source (apart from the espressif wifi radio stack, but who’s counting) and low cost.
Yes, quality of the camera will never compete with commercial stuff, but this is way more fun. Add as much cameras as your frigate instance allows…
Gonna recommend this to all my co workers.
It is not vulnerable to Windows viruses.
:-)
Blowtorch will heat this up way too hot.
Try to get it to a high enough temperature to insert filament to do a cold pull and repeat…
Electrical heat gun (paint stripper) is hot enough. Gas based torches will change the stiffness of your material and you will regret it.
Yes, physically getting bigger.
Dell XPS had a batch laptops going crazy and pushing the touchpad up.
You will recognize it :-)
This.
Using a CEC link will make things even more simple, but that might involve additional hardware. Those raspberry thingies have native CEC on hdmi. For x86 you might have to look at some extra hardware.
And of course, Kodi is an example of a 10 foot interface.
Bluetooth or wifi, depending on the number of accesspoints…
Anyway, a really smart hack!
Sony SRS-RA8000 owner here. Can confirm it works with the plugin mentioned above.
Using Harman Kardon hardware yields in a way less happy experience.
NetApp makes storage devices, just like Dell’s DataDomain.
Looks like the ad is referring to a ST6000NM0034, a drive from Seagate. Personally, I like to stay away from that brand as far as possible.
Have had good experiences with WD.
Yes, as an alternative to klipper -this really is your end goal - use the firmware by mriscoc, it is really nice and robust.
Gives you more options and the results are better than the stock fw.