It looks like the pumpkin body curves over and then down to the stem, so it would be a lot of filament swaps.

Honestly, I haven’t used Kodi in a lot of years. There are add-ons for things like Netflix and YouTube, and I vaguely recall using those.

I found this, for example: https://howtomediacenter.com/en/install-netflix-kodi-addon/

If you can get a UI set up, like Kodi or something, I liked using my Flirc receiver on my htpc. You can use any IR remote, and completely map the buttons to functions. It was sweet.

In that case I would seriously contact Google, and either completely reflash either factory Android or one of the ALTs available.

Where did you buy your phone? What kind of phone is it?

10 x Computer Case Thumbscrews (6-32 Thread) PC Computer Case Fastener Thumb Screws,for Cover/Power Supply/PCI Slots/Hard Drives https://a.co/d/hm14iKl

Hasn’t that been said for like 30 years?

Now it’s just the Neighbor of the Beast

RatRig V-minion uses printed (ASA/PETG) parts for all motors, and 10k mm/s² acceleration is normal. Granted, a smaller bed slinger, but still.

The big one? That’s a coextrusion silk bicolor blue-green. I love the coloring, but it’s kinda a PITA about bed adhesion.

https://www.printables.com/model/209121-cali-dragon

https://www.printables.com/model/209121-cali-dragon

It’s a fun little filament test.